Beams of light

Kinetic sculpture resembling beams of light cutting through fog or smoke. Made from square tubing and different sizes of round tubing. The cube spins on a 1/2 inch shaft set into two bearings. The base is painted grey and the cube is clear coated bare metal.

Split Bend

Made from 1 1/2 inch square tubing and 1 3/4 inch split, bent and straight pieces of round tubing. The whole piece is painted hunter green and then the front facing edges are sanded to bare metal.

Red Split Ends

16x16 inch frame made from 1 1/2 inch square tubing with 1 3/4 inch round tubing pieces inside. The whole piece is painted colonial red and then the front facing edges are sanded to bare metal.

Black Split Ends (mini)

6x6 inch frame made from 3/4 inch square tubing with 1 inch split round tubing pieces inside. The whole piece is painted black and then the front facing edges are sanded to bare metal.

Twisted Bamboo

Twisted Bamboo zigzagging and twisting up 9 feet tall. Welded to a 1/2 inch plate it starts with 2 1/2 inch tubing and tapers up to 1 inch tubing. The 14 gauge metal leaves twist and get smaller as they go up. The sculpture is painted to give the affect of different levels of bamboo growth and clear coated.

large Twisted Tree

7 foot tall version of the original Twisted Tree. Designed to exaggerate the movement of a tree in the wind with strong roots securing it to the ground. Made out of 14 gauge steel plate and 1, 1/4 inch steel tubing. Painted with outdoor paint and clear coated.

Small Coopers Hawk

Small bronze Coopers Hawk on a rock. Sculpted in clay and then cast in Bronze by Blue Mountain Fine Art. 10 inches tall from base to top of head. Base is threaded for mounting. 2/10 through 10/10 available and made to order.

Large Coopers Hawk

Life size bronze Coopers Hawk. Sculpted in clay and cast in bronze by Blue Mountain Fine Art. It stands 10 inches tall from the feet to the top of its head. 16 inches from the end of tail to tip of beak. The feet are threaded for mounting. 7/10 through 10/10 available and made to order.

Twisted Tree

The original design was made from a piece of 22 gauge sheet metal and was only 2 inches tall. This one is also made from 22 gauge sheet metal and braced with 1/4 inch round stock. It is about 16 inches tall. Finished with a torch for color.

Ring Holder

Carved hand ring holder. Carved from cherry wood. Made to the scale of the clients hand and ring sizes. It is finished with a clear varnish.

St. Johns Bridge

Plasma cut design of Portland Oregon's St. Johns Bridge. Cut into 1/8" steel plate and frame with 3/4" steel angle. Its finished with a clear coat.